Archive for August, 2011

Pinnacles Earthquake Swarm–22 to 28 August 2011

A swarm of more than 60 mostly small magnitude earthquakes, the lion’s share smaller than 3.0 M events, occurred over the past week about 4 to 6 miles northwest of Pinnacles, California.  Pinnacles is situated along the San Andreas fault system in central California.  The events began on 22 August and continued through the morning of 28Pinnacles Swarm Aug 2011 August.  Nine events were in the 3.0 to about 3.6 Didyoufeelit 4-6range.  The largest event, which occurred just after midnight (PDT) on 27 August, was a 4.6 M event.   Shaking was light,  nonetheless more than 2000 people reported it to USGS’s “Did you feel it”. 

Mike Conway (28 August 2011)

Trinidad, CO Earthquake Swarm–August 2011

colorado swarmMedia attention today focused like a laser on the 5.8 M Mineral, Virginia, earthquake that shook the Eastern seaboard from Atlanta, Georgia, to Maine.  And that is as it should be, the event rocked Washington D.C. and New York City and send thousands of people scurrying into the streets.  The USGS’s “Did you feel it” recorded nearly 14,000 reports from 3754 zip codes and 33 cities.  While strong shaking was localized, moderate shaking was reported widely.   For additional information and maps visit the USGS’s events page. 

The Mineral earthquake overshadowed what otherwise was a newsworthy seismic swarm of moderate- to low-magnitude events on the Colorado-New Mexico border 9 miles WSW of Trinidad, Colorado.  (Broadband seismometers of the Arizona Integrated Seismic Network nicely captured the Mineral event and the two largest Trinidad events.)AISN Snowflake seismogram

The Trinidad swarm began with a 4.6 M event at 5:30 p.m. (MDT) on 22 August and continued through 8:11 a.m. (MDT) the next morning.  In all, 11 events occurred.  The largest event was a 5.3 M that occurred at 11:46 p.m. (MDT) on the evening of 22 August;  this is also the largest event reported for the area since 1973.   Small to moderate magnitude earthquake are not uncommon here – unlike the rare 5.8 M near Mineral, Virginia – and eight M 4.x events have occurred over the past decade. 

The causative fault(s) lack any surface expression and thus are not included on the interactive USGS Quaternary fault map of Colorado-New Mexico.  Nonetheless, the past day’s events and didyoufeeit_5.3MTrinidadthose of a swarm in 2001 are consistent with a north-northeast trending fault system, congruent with east-west extension responsible for forming the Rio Grande Rift. 

Michael Conway (23 August 2011)

Earthscope & USArray Roll on

Earthscope’s mission is to explore the structure and evolution of the North American continent.  Their chief tool is the portable array of 400 seismometers, USArray, rolling across the country from west to east.  The us array 1first footprint was established in 2007 in the western-most U.S.  Since then the stations have rolled on and are now deployed from Texas and North Dakota in the west to Alabama and Wisconsin in the east.

Data from USArray fuels models of the structure, i.e.,  fault distribution and geometry, of the Earth’s crust.  If that seems a bit esoteric, those data provide insight into seismic, volcanic and landslide hazards in the continental U.S.  This type of large-scale science research has the potential to benefit us all directly or indirectly for generations. 

Check out this really fascinating animation of USArray capture of seismic wave propagation from an M 6.0 earthquake near Wells, Nevada on 21 February 2008 (animation).  Us array crustal structure

Background.   From the USArray website, “Each of the Transportable Array stations consists of a three-component broadband seismometer with associated signal processing, power, and communications equipment. In the early phase of the experiment, significant effort was devoted to the design of the temporary vaults to house the instruments, which resulted in a configuration that provides both high-quality data and a data return of greater than 90%.”

Important Links

Michael Conway (21 August 2011)

Quake Catcher Network

 

QCN 2

The Quake Catcher Network (QCN) is hard at work in the San Francisco Bay area recruiting citizen scientists, deploying low-cost strong motion seismometers, and capturing earthquake data.  From QCN website, “The Quake-Catcher Network is a collaborative initiative for developing the world’s largest, low-cost strong-motion seismic network by utilizing sensors in and attached to internet-connected computers.”

And as part of their program, they focus on recruiting schools and thereby getting teachers and students involved.  Currently, the program is piloting in parts of western and central U.S. — California, Oregon, Washington, the Wasatch fault in Utah, and the New Madrid fault zone of Missouri – where the probability of  large-magnitude earthquakes are greatest. 

Technorati Tags:

Sounds like a truly excellent program. Their sponsors include NSF, IRIS, Southern California Earthquake Center, O-NAVI, and United Parcel Service (UPS)

Check them out at Quake Catcher Network.A QCN strong motion sensor.

Day 2 – Post-Earthquake Safety Evaluation of Buildings

day2 FEMA training in Somerton, AZ, today focused on ATC-20; evaluating building safety/integrity following an earthquake.  Chiefly we reviewed the ATC-20 form and engaged in discussion on how to recognize building type – i.e., material (wood, steel, concrete, unreinforced masonry) — and how to recognize potential structural and non-structural hazards. We were then presented with a suite of slides of damaged buildings and using the ATC-20 posting system — green – inspected and safe for occupation; yellow – safe for limited entry; red – unsafe, no egress – made selections based on ATC-20 criteria regarding building safety.

Mike Griffin also introduced the electronic version of Rapid Observation of Vulnerability and Estimation of Risk (ROVER), which uses Windows mobile smartphone to gather and transfer data.  The open source software remains in development stage but FEMA plans to release it later in 2011.

Mike Conway (11 August 2011)

FEMA 154 – Training in Somerton, AZ

I joined about 45 others today in Somerton, AZ, to participate in FEMA 154 – Rapid Visual Screening of Buildings for Potential Seismic Hazards. Gretchen Robinson of Yuma County Office of Emergency Management hosted the event and Mike Griffin, P.E., conducted the training.  The participants represented Yuma county and local municipal agencies, including the Somerton Fire Dept

After lunch, we applied the RVS tool to several nearby buildings.  It was a challenge but we passed the test.

For more information on FEMA 154

 

Mike Conway (10 Aug 2011)

FEMA Training Group, Somerton, AZ, 10 Aug 2011

Go to Top